Audi fault code u101400 I looked up the online codes and it provided my with a list of 10 different codes. I've had error code U101400 being reported before I made any OBDEleven changes to my car and never made any changes to the Telematics module 75 so it's unlikely related to the MyAudi app issues. I am trying to calibrate the new module however it says that the module is incorrectly coded. I am getting U101400 - Control module incorrectly coded now on a full scan and also sometimes the indicator clusters hyper flash. I don't understand how it happened? New user and new to do coding at my car. I have attached the error log and a full back of my central electrics. I tried to switch these on to see if I could activate Bluetooth, but that did not work, so i went bag in and sat it all back to where it was. I am trying to do long coding for (a) Wireless Apple carplay (b) connecting videos from youtube on the heads up display (c) easy entry & exit for driver (d) tail light animation. Error U101400 Control module incorrectly coded - Hello, There is a post about different hacks for SQ7s one of them was to attempt to enable RS light animation but I made a stupid mistake and did not fully read that it is not supported. I didn't change anything with Telematics Communication Unit. The tail lights function perfectly but I have a dash light error that says "Fault: Vehicle Lighting" and in OBDeleven the fault says "Control Module Incorrectly Coded" with a Customer: Hi I changed the ACC module on my 2018 Audi SQ5 prestige. Anyone else have intermittent faults on Module 19 (U142100: Control module for emergency call module and communication unit) and 75 (U101400: Control module incorrectly coded). I think this is what causing the Audi connect to check the Vehicle Status Report after a minute of turning the car off and locked it. I've had error code U101400 being reported before I made any OBDEleven changes to my car and never made any changes to the Telematics module 75 so it's unlikely related to the MyAudi app issues. However when I run a scan I keep getting faulty error U101400 Control module incorrectly coded under module 17-dashboard (Which I have not touched and there is on history of any changes) The only issue I noticed is that the I have a fault that won't clear after installing and coding the MK7. 5 Euro OEM tail lights. I have a 2023 Audi Q5 in India. This seems more comforting. . I was going through the 5F module, and saw a few options regarding Blurtooth. lhjvnv xek lvaa aohp ybxxv mzhpo rulhcx fncjw equxhl iywuctk